Android BMW X1 E84 Navigation GPS Installation manual

Android BMW X1 E84 Navigation GPS Installation manual

When you order the after-market Android BMW X1 navigation, what should pay attention to before placing an order?

For the BMW X1 E84 2009-2015, if the car without an original screen, also without iDrive, for this kind of car, you should order the [B219], our model with an iDrive knob included.

Downlaod the installation wire-diagram (Without OEM screen) as below:

If your BMW X1 E84 2009-2015 contains a factory screen, as we know, that is the CIC system, the LVDS is 4 PIN, you should order the [B239], it will use your factory iDrive system, your iDrive also work in our android menu.

    Downlaod the installation wire-diagram (CCC CIC NBT) as below:

    How to replace factory BMW X1 E84 2009-2015 auto radio and CD system with aftermarket navigation android screen?

    Installation steps:

    Before installation (if your BMW X1 with CIC system, then it will be a factory screen)
    bmw x1 e84 original central console

    1: Remove the AC vents (start from the left side)     2, Remove the connection on the back of AC outlet Panel

     remove the AC vents from BMW X1 E84 dashboard and take off the connections on the back


    3: Remove the 2 screws inside of the dashboard     4: After the screws were removed, then can remove the storage box

     remove 2 screws so that to take off the storage box from bmw x1


    5: Remove the cover around the gear     6: Notice there is a flat cable on the back of this cover, don't break it

     remove the plastic cover from the central console

    7: Remove the climate control panel    8:Remove the two screws inside, so that to remove the factory CD head unit

     take off the AC control panel and remove the two screws


    9, Take out the factory CD head unit, and remove all existing harness    10, Remove the cover around the gear so that to install the iDrive knob.

     disconnect all the harness on the back of factory radio and take off the cover in the central console


    11, Install the iDrive knob here     12, iDrive was installed

     install the idrive knob to the dashboard


    13, Remove the optical fiber from the factory power harness     14, Connect the optical fiber to our power cable (Female)

     remove the optical fiber and insert it to our power harness


    15, Connect our power cable (female) to factory CD head unit    16, Connect our power cable (male) to factory harness (female)

     connect our power cable to factory radio, an other side connect to factory power harness


    17, Connect the AUX cable    18, The AUX cable was well connected

     connect the aux cable


    19, Connect Power cable / GPS antenna, USB, etc to the back of our android screen    20, location the GPS antenna and USB cable

     connect the power cable,USB,GPS antenna to andriod screen and location the gps antenna and USB


    21, Double check the connections and recover the car dashboard, the installation is done

     double check all the wires connection and recover the bmw x1 e84 dashboard , the installation is done


    Video Demo for wire connection (BMW X1 E84 Android Screen)





    Write a comment

    Comments are moderated