Installation for BMW 3/4 series Navigation GPS (For BMW F30 ~F36 2013-2018)

Installation for Android Navigation GPS BMW 3/4 series F30 ~F36 (2013-2018)


For BMW 3 Series F30/F31/F34/F35(2013-2016), BMW 4 series F32/F33/F36(2013-2016),with NBT menu, you should order [B213]

For BMW 3 Series (2018) or BMW 4Series (2017-)  Original EVO menu, without factory touch screen, then you should order [B513].

If the BMW 3/4 series 2017-2018 model with factory EVO menu and Touch screen,you need to let us know this situation,we need to change the software and hardware for you specially, read more

How to replace factory BMW 3 / 4 series F30~36 2013-2018 with aftermarket navigation Android Screen?

Installation steps

1: Remove the dash panel 2, Remove the 2 connections on the back of dash panel

bmw 3 4 series navigation installation : remove the dash panel

 

3: Remove the plastic cover in the bottom 4: Take off the connector from the plastic cover

remove the plastic cover in the bottom and take off the connector on the back

 

 

5: Remove 4 screws and take out the CD/AC panel 6: Remove the connector on the back of CD/AC panel

remove the screws and take out the CD/AC panel

 

7: Remove 4 screws showed as below photo 8: Slide the head unit forward and take out the head unit

take off the screws and slide forward the CD head unit


9,Remove all exsiting harness on the back of head unit 10, Connect our power cable (male) to factory harness (female).

remove all exsiting harness and connect with our power cables

 

11, Wiring the power cable/usb cable/GPS antenna (go up behind the plastic cover to the top ) 12, wire diagram showed photo as below (ps:the LVDS connect to the back of our android screen)

wiring the power cable/ gps antenna, lvds, usb etc

13, Connect and location the GPS antenna 14, Location the USB connector (inside the glove box)

connect and location the usb,gps antenna

15, Connect the power cable/USB cable/ LVDS/GPS antenna to the back of android screen 16, Insert the android screen to dashboard

connect the power cable/lvds,usb etc, to the back of android screen, and install the screen to the dashboard

17,For some kind of cars, the sound not work via Can bus, in this case, it need to connect the AUX cable,otherwise it will no sound output

connect the AUX cable (for some kind of car models)

 

18,Connect the power cable (also connect all other harness) back to the head unit,And install the head unit back to the car, recover the dashboard.

connect the power cable to factory head unit and install back to the dashboard

 

Recover the car dashboard, done.

 

 

 

Comments

0 comments

Write a comment

Comments are moderated