Installation manual for BMW X3 X4 Navigation GPS Android screen replacement

Installation manual for BMW X3 X4 Navigation GPS Android screen replacement

This article with below contents:

A, How to replace factory BMWX3 X4 F25/26(2011-2016) auto-radio and CD system with aftermarket navigation Android Screen.

B, When you order the aftermarket Android BMW X3 X4 Navigation, what should pay attention to before placing an order?

  • For the BMW X3/X4 F25/F26 (2011-2013), It is CIC system, the LVDS is 4 PIN, Thus, you should order an 8.8 inch screen [B253]  or 10.25-inch screen [B243]

 

  • If your BMW X3/X4 F25/F26 (2014-2016), it is factory NBT menu, the LVDS is 6 PIN, thus, you should order 8.8-inch screen [B223]  or 10.25-inch screen [B263]

Downlaod the installation wire-diagram (CIC NBT) as below:

 

Installation guidence:

Before installation

 bmw x3 x4 original central console

 

1: Remove the cover in the bottom    2, Remove Vents

 remove the cover in the bottom and take off the vents under the factory monitor

 

3: Remove 3 connectors on the back of vents    4: Remove the 6 screws so that to take off the factory monitor & AC control panel & Radio control panel

 take off 3 connectors on the back of vents and remove 6 pcs screws in the central console

5: Remove 2 connectors on the back of AC control panel   6: Remove 4 screws, then remove the factory radio head unit

 Remove connectors on the back of AC control panel   remove 4 screws and remove the factory radio head unit

7: Remove the original power harness from the radio head unit   8: Remove the 2 optical fiber cable from the factory harness, and insert it into our power cable (female connector)

 disconnect all the harness on the back of radio head unit, and move the fiber cable to our power harness

9, Connect our power cable (female) to factory CD head unit   10, Install the factory radio head unit back to the dashboard

 connect the power cable to factory head unit and put back to the dashboard

11, Remove the LVDS cable from the factory screen   12, Connect the Power cable/LVDS/GPS antenna /USB cable to the android screen

 take off the lvds from factory screen and connect all cables to android monitor

13, Install the android screen     14, Recover the dashboard, the installation is done

 install the android screen and recover the car dashboard

 

 

 

 

Comments

0 comments

Write a comment

Comments are moderated